capinator

← All device types · ← Monitor / TV · ← Commodore · ← 1702

Commodore 1702 — (NTSC, 110v) / MAIN PB ASSY shared

Device type
Monitor / TV
Device
Commodore 1702
Board
(NTSC, 110v) / MAIN PB ASSY
Visibility
Public

— anyone with the link can view this list.

Component type

Default type
aluminium electrolytic

Part quality

The bars this list's parts were searched under. Individual rows can lift a bar — check the table's policy columns.

🌊 About ripple current

The ripple policy column lets you select capacitors for their ripple-current handling.

Ripple current is a rating, not a defect — it tells you how much AC current a capacitor can carry continuously without overheating. Higher is generally better, so "low ripple" and "high ripple current" are the same request said from opposite ends. For otherwise comparable parts, higher ripple-current capability usually goes with lower ESR; lower ESR reduces the ESR component of ripple voltage and, just as importantly, reduces self-heating.

Set it per row, on purpose. Ripple current matters mainly for reservoir and smoothing capacitors after a rectifier, and for capacitors carrying substantial switching ripple in SMPS and deflection circuits. It is usually not a useful selection criterion for small coupling, bypass, or signal-decoupling capacitors. Asking for a high ripple-current rating there can simply steer the BOM toward larger, more expensive parts without a practical benefit. Add the ripple policy column in the table editor and set it only on rows where the capacitor carries meaningful ripple current.

The two ripple choices answer different questions. Mains rectifier targets the low-frequency ripple associated with rectified mains — typically 100/120 Hz after full-wave rectification, depending on 50/60 Hz mains. Switching or scan targets the kHz-range ripple found in switch-mode supplies and circuits such as monitor deflection stages. The same capacitor can have different ripple-current ratings at different frequencies because ESR changes with frequency, so a part that is excellent at one frequency may not be the best choice at another.

This is a preference, not a hard filter. It only ranks parts that already meet the other electrical and mechanical requirements, so a row cannot fail selection because of ripple policy. Expect to pay roughly proportionally for extra headroom — measured at about 1.8× the price for 1.8× the rating across a small sample — but treat any such multiplier as a heuristic rather than a guarantee.

Also keep capacitance separate from ripple current. The bulk voltage sag between charging pulses is primarily determined by capacitance and load current; a like-for-like recap therefore preserves that basic behavior. What a higher-ripple/lower-ESR part improves is the ESR-related ripple, current spikes, transient behavior, and the heat generated inside the capacitor.

Source list (23 components)

Capacitors — Aluminium electrolytic (23)

What was found What was asked for
Resolved Manufacturer Temp Lifetime Ripple qty capacitance voltage designator manufacturer_policy lifetime_policy polarization temp_policy
✓ Rubycon -40°C ~ 105°C 6000 Hrs @ 105°C 300 mA @ 120 Hz 1 470 6.3 C101
✓ ⚠ Nichicon -55°C ~ 105°C 2000 Hrs @ 105°C 55 mA @ 120 Hz 1 33 6.3 C102 any any
✓ Rubycon -40°C ~ 105°C 7000 Hrs @ 105°C 480 mA @ 120 Hz 2 470 16 C103, C403
✓ ⚠ Würth Elektronik -40°C ~ 105°C 2000 Hrs @ 105°C 35 mA @ 120 Hz 4 10 16 C201, C316, C343, C701 any any
✓ Rubycon -40°C ~ 105°C 5000 Hrs @ 105°C 22.26 mA @ 120 Hz 1 3.3 50 C203
✓ ⚠ Nichicon -55°C ~ 105°C 1000 Hrs @ 105°C 22 mA @ 120 Hz 1 3.3 50 C204 any any NP
✓ Rubycon -40°C ~ 105°C 6000 Hrs @ 105°C 270 mA @ 120 Hz 5 220 16 C208, C315, C506, C602, C607
✓ Rubycon -40°C ~ 105°C 5000 Hrs @ 105°C 175 mA @ 120 Hz 2 100 25 C303, C702
✓ ⚠ Würth Elektronik -40°C ~ 105°C 2000 Hrs @ 105°C 7 mA @ 120 Hz 1 0.47 50 C305 any any
✓ ⚠ Würth Elektronik -40°C ~ 105°C 2000 Hrs @ 105°C 26 mA @ 120 Hz 1 4.7 25 C314 any any
✓ ⚠ Nichicon -40°C ~ 85°C 2000 Hrs @ 85°C 42 mA @ 120 Hz 1 10 16 C342 any any NP any
✓ ⚠ Würth Elektronik -40°C ~ 105°C 5000 Hrs @ 105°C 62.5 mA @ 120 Hz 1 22 35 C407 any
✓ Rubycon -40°C ~ 105°C 7000 Hrs @ 105°C 280 mA @ 120 Hz 1 100 35 C423
✓ Rubycon -40°C ~ 105°C 5000 Hrs @ 105°C 665.5 mA @ 120 Hz 2 470 25 C424, C531
✓ Rubycon -40°C ~ 105°C 10000 Hrs @ 105°C 907.5 mA @ 120 Hz 1 470 35 C425
✓ Rubycon -40°C ~ 105°C 8000 Hrs @ 105°C 472.5 mA @ 120 Hz 1 220 35 C502
✓ Rubycon -40°C ~ 105°C 5000 Hrs @ 105°C 10.5 mA @ 120 Hz 2 1 50 C504, C601
✓ Rubycon -25°C ~ 105°C 10000 Hrs @ 105°C 260 mA @ 120 Hz 1 33 160 C523
✓ ⚠ Rubycon -55°C ~ 105°C 1000 Hrs @ 105°C 14 mA @ 120 Hz 1 2.2 50 C530 any any NP
✓ Nichicon -40°C ~ 105°C 5000 Hrs @ 105°C 19 mA @ 120 Hz 1 1 160 C541
✓ Rubycon -40°C ~ 105°C 10000 Hrs @ 105°C 907.5 mA @ 120 Hz 2 1000 16 C551, C610
✓ Rubycon -40°C ~ 105°C 5000 Hrs @ 105°C 42 mA @ 120 Hz 2 10 50 C603, C604
✓ ⚠ Würth Elektronik -40°C ~ 105°C 5000 Hrs @ 105°C 32.5 mA @ 120 Hz 1 10 35 C703 any

23 rows · 36 capacitors

CSV

Resolved parts

Latest (2026-08-23 19:57, 1 DigiKey queries)

Desktop browsers only for now — on mobile the DigiKey app intercepts this link and it won't open. Use the Copy button and paste into DigiKey's bulk-order form instead.

History (4 resolutions)
  • 2026-08-23 19:57 — 1 queries
  • 2026-08-23 19:56 — 7 queries
  • 2026-08-23 19:55 — 9 queries
  • 2026-08-23 19:54 — 23 queries